The Guide to Change 6th Gen Honda Accord Projector Headlights

We are going to install a hid projector headlight for the Honda Accord. Before we get started, you’ll need a 10-millimeter socket and ratchet a Philips head screwdriver and a panel popper.

The Guide to Change 6th Gen Honda Accord Projector Headlights

First to start by opening the hood. You need to remove the two Philips retainers on either side of the grill. After removing the Philips retainers component, remove the two retainer plugs on either side of the grill. Before we move on, take a moment to apply painters tape or masking tape to protect the paint. While we’re working remove the 10-millimeter bolts, securing the corner of the front bumper fascia. And then move on down and remove the lower ten millimeter bolt at the corner of the fascia, moving to the center, remove the four plastic retainers.

The Guide to Change 6th Gen Honda Accord Projector Headlights

Now we can go ahead and unseat the front bumper fascia, remove the 10 millimeter bolt and the clamp plate from the upper headlight tab. Then remove the 10-millimeter bolts securing the corner of the headlight bracket, remove the two inner 10-millimeter bolts, securing the headlight bracket, remove the headlight bracket but hang on to it as we’ll need it later.

Go ahead and unseat the headlight then disconnect the low beam harness, remove the turn signal socket, disconnect the high beam harness and remove the marker lamp socket. The headlamp adjuster are located in the four corners of the bulb.

The Guide to Change 6th Gen Honda Accord Projector Headlights

Locate your headlight, connect the high beam harness, then connect the low beam harness. Reinstall the marker lamp socket, then reinstall the turn signal socket, then go ahead and seat the headlight.

The Guide to Change 6th Gen Honda Accord Projector Headlights

Reinstall the headlight bracket and the 10-millimeter bolts, securing the bracket at the corner. Reinstall the two inner 10-millimeter bolts, securing the bracket. Reinstall the 10 millimeter bolt and clamp plate, securing the upper headlight tab. Now we can go ahead and seat the front bumper fascia, reinstall the lower ten-millimeter bullets at the corner of the fashio. Reinstall 10-millimeter bolts securing the corner of the front bumper fascia. Reinstall the four plastic retainers securing the undertray to the fashio, then reinstall the two retainer plugs on either side of the grille opening. Next, reinstall the two Phillips retainers then just close the hood and you’re done. If you are interested in car headlight retrofitting, you can find more new headlights for Honda Accord on Carid.

Leave a Reply

Your email address will not be published. Required fields are marked *

All the content are published under the GNU General Public License. All rights images and videos in this site reserved owned by its respective owners. 2019 Copyright. Powered by Dessign Theme